Home / News / Industry News / Jump Start Car Service -Life Of Jump Starter

Jump Start Car Service -Life Of Jump Starter


If you follow these steps, you can keep the starter in […]

If you follow these steps, you can keep the starter in good working condition and have a long service life. Keep in mind that these steps can increase the life of a jump starter by up to 2-3 times compared to not following them.
The jump starter is charging to avoid leaving the device in a high discharge state for a long time. Keep in mind that the Quick Start battery has no storage issues, and even a slight discharge will not be damaged by frequent charging. The best practice is to charge the starter after each use. Even if this charging frequency is impractical, if you use the unit often, you should charge it every night. If the starter is not used often, please charge it every 3 months to ensure that the battery does not discharge for a long time.


Respect the duty cycle of your starter. Each trip starter has a duty cycle, in which case the vehicle can only be shaken after a certain amount of rest time (for a trip starter) is required-for more information on trip starters, see the Operating Manual manual. For almost all jump starters, the recommended duty cycle is a start time of 6 seconds, followed by a 3 minute rest. This prevents excessive heat build-up in the starter battery, which would otherwise damage its internal structure and shorten its service life.


If possible, store the starter in a medium temperature environment between 50 F and 70 F (10 C -20 C). Like automotive batteries, short-term or long-term exposure to extreme temperatures can adversely affect starter batteries. For example, stored at 20? F jump starter will be stored at 60? F's jump starter has less jump start power. In the long run, prolonged exposure to high storage temperatures (> 90? F) will shorten the life of fast-start batteries.



After successfully completing the jump start, it is important to disconnect the jump starter from the moving vehicle as soon as possible, always keeping in mind all safety procedures and the correct disconnection sequence. The typical output of a vehicle alternator is much higher than the recommended charge rate of a jump starter battery. Charging the battery (any battery) at a rate higher than the recommended charging rate may harm its long-term health. After a successful startup, many technicians keep the Quick Launcher connected as a quick and easy way to fully charge the device, but this practice should be avoided.




So far, our focus has been on the battery, which is at the heart of quick start and the most critical component affecting its durability and life. That said, other factors should be kept in mind. Keep in mind that many of the batteries in contact with the starter are in poor condition, which may cause acidification of the battery on or around the post. In this case, after the vehicle with the battery bounces, wipe the clips (especially the positive electrode, which is the only clip that should contact the battery) with a clean cloth to remove the remaining battery acid. For highly acidic luminaires, a wire brush can be used with a mixture of baking soda and water.

Following these simple steps can greatly extend the life of your starter starter and help ensure that it can be repaired every time you need it. Linsheng is a professional Jump Start manufacturer and Jump Start supplier in China. Professionally provide    Jump Start Car Service     . Welcome to buy our automotive quick start products.